Abstract
A semi-distributed optical fiber bending extensometer system based on OTDR is proposed, consisting of N-loops designed to enable different maximum extension measurements and sensitivities. This system offers a low-cost solution for monitoring landslides and similar civil structures. Tests conducted at 1625 nm demonstrate that different series of sensors can be independently measured with elongation errors typically within +/- 0.25 cm across a range from 0 to 9 cm.

Abstract
A flexible wearable sensor utilizing a balloon-shaped interferometer structure, created from a bent standard single-mode fiber and a 3D-printed piece, was introduced and shown for respiratory monitoring. The interferometer is a compact, cost-effective, and easily fabricated sensor. The fiber's curvature causes interference between the core and cladding modes, which in turn results in the sensor operation. In the balloon-shaped curving section, light traversing the core partially escapes and interacts with the cladding. The preliminary results demonstrate an average displacement of 9.3 nm and the capability to evaluate breathing rate.

Abstract
A sensor based on the fiber Bragg grating (FBG) and additive manufacturing for diameter variation measurement is proposed and experimentally demonstrated in this work. Two designs were proposed: a FBG alone and a FBG in series with a spring. Three tests were developed for each design, and at the end, the statistical treatment was performed. The designs were fabricated using a 3D printer, and the FBG sensor is embedded. The results demonstrated that the structures proposed in this work can be used to monitor diameter variation, among other applications. The sensors, with and without spring in series, presented sensitivities of 0.0671 nm/mm and 0.5116 nm/mm, respectively, with a good linear response greater than 0.99.

Abstract
In this letter, we propose a method for utilizing the internal cavities of optical circulator devices-commonly referred to as parasitic cavities-as optical reference cavities. The method involves using an optical circulator operating at 1550 nm, illuminated by a light source at 1330 nm, thereby enhancing the amplitude of the interferometric signals generated by the internal optical cavities. The system was characterized by using both an Optical Spectrum Analyzer (OSA) and the Low-Coherence Interferometry (LCI) technique. Experimental results indicate that the Optical Path Difference (OPD) remains constant with varying aperture sizes, thereby confirming the feasibility of employing the optical circulator as a reference sensor. Finally, its performance as a reference sensor is demonstrated through its integration with an external cavity that functions as a displacement sensor.

Abstract
Azobenzenes are a class of compounds which allow the writing and erasure of linear birefringence along any desired direction, through their ability to photoisomerize. This property enables applications requiring polarization control, which, despite extensive exploration in the visible spectrum, have yet to be fully capitalized in the infrared region. This study aims to systematically characterize the creation and relaxation of induced linear birefringence dynamics in azopolymers thin films for the 1550 nm region. Maximum birefringence values as high as 6.02 x 10(-2) were attained during the recording phase with a 445 nm pump laser, that stabilized at 5.40 x 10(-2) during the relaxation phase, achieved for a 2.4 mu m sample. In addition, a maximum phase shift of Delta Phi = 0.54 pi stabilizing at Delta Phi = 0.50 pi, was observed for a 9.7 mu m sample with a 532 nm writing laser. Accordingly, this shows the promising potential of azopolymers for many applications.

Abstract
In this study, we demonstrate the measurement of electric power using an optical ground wire ( OPGW). The tests were conducted on an OPGW cable from a high-voltage transmission line in Sines, Portugal, operating at 400 kV. A buried fiber position, free of 50 Hz and 100 Hz frequency interference, was selected to confirm that the 50 Hz frequency is not due to mechanical perturbation or electronic noise. Additionally, two suspended fiber positions (at 2500 m and 8500 m), where these frequencies were clearly observed, were analyzed. This study also examined the positioning of poles and splice detection between cables.