Abstract
We present results on the measurements of polarization dependent loss (PDL) of mechanically induced long-period fibre gratings. It is shown that a proper choice of the fabrication parameters leads to a considerable reduction of PDL values.

Abstract

Abstract
The symmetry of cladding modes excited in microbend and arc-induced long-period fiber gratings is investigated. An optimization technique is developed to determine the fiber parameters and to associate grating resonances with cladding modes of a particular symmetry. Using this optimization procedure, we show that the gratings induced in a standard fiber by arc discharges and microbends couple light to the antisymmetric cladding modes. In the case of a boron-germanium codoped fiber, the cladding modes excited by arc-induced gratings are found to be symmetric. Measurements of the near-field intensity distribution of cladding modes confirm the mode symmetry ascertained by the optimization technique. (c) 2006 Optical Society of America

Abstract
We demonstrate that under certain conditions it is possible to fabricate in a B/Ge co-doped fiber an arc-induced long-period grating whose spectrum contains a dual set of resonances. These two sets of resonances are formed by distinct mechanisms and are caused by coupling to cladding modes of different symmetries. They behave differently at high temperatures: the set produced by symmetric perturbation disappears during annealing at a temperature of 800 degrees C, while the other set produced by an antisymmetric mechanism can withstand temperatures above 1000 degrees C. (C) 2007 Optical Society of America

Abstract
We study the origin of antisymmetric perturbation of the fiber in arc-induced long-period gratings that couple the core mode into the antisymmetric cladding modes. We demonstrate that this perturbation is caused by the temperature gradient in the fiber, which is induced, in turn, by the temperature gradient in the arc discharge. The reproducibility of the process of the grating inscription is higher when the fiber is placed in a region with larger temperature gradient. (c) 2007 Optical Society of America.

Abstract
Long-period fiber gratings (LPGs) have been inscribed in nitrogen-doped fibers by electrical arc discharge. The influence of drawing tension as well as external load applied during arc discharge on coupling strength has been investigated. The influence of drawing tension on the grating's coupling strength is found to be negligible, whereas the coupling strength increases considerably with external load. Tomographic stress profiles of the fiber have been recorded before and after electric arc discharge. The axial stress modulation in the core region of the grating was found to be smaller than 10 MPa and is thus too small to be the dominating mechanism for grating formation.