Abstract
A Fabry-Perot (FP) cavity of simple design and based on a pure silica diaphragm-free hollow tube is proposed. Its operation is based on a first reflection of light at the end of the single-mode fiber that illuminates the silica rod and in a second reflection that takes place at the end of the rod. The FP cavity is characterized for high temperature, pressure and refractive index sensing, showing useful characteristics for the measurement of these three parameters. The diaphragm-free configuration simplifies the measurement of the refractive index of fluids. (C) 2011 Optical Society of America

Abstract
The underground movement of water through soil and rock is an important phenomenon in Civil Engineering. Its study is made more appealing to students if small scale prototypes are used, where several layouts of soil and water in steady state/transient conditions can be studied in detail. A water tank prototype was built with a reflective optical fibre pressure sensor based on a GRIN lens and a mirror. The mirror is connected to an elastic membrane that is deformed when water pressure is applied and the lens is correctly aligned with the mirror and fixed. The distance between the mirror and the lens changes, so the reflective optical power changes as well and it is directly proportional to the water pressure inside the tank. The results obtained for water pressure up to 4 kPa for filling and emptying operations show that the sensor has a linear response for pressure changes between 1.7 kPa and 3.4 kPa with a slope of 181 mu W/kPa for filling and 191 mu W/kPa for emptying. It is also observed some hysteresis that may possibly be reduced by choosing another material for the membrane. Using this type of sensor head it is possible to monitor different pressure points in the small scale prototype using the standard OTDR (Optical Time Domain Reflectometer) equipment.

Abstract
A novel interrogation technique for multiplexing LPG-fiber loop mirrors has been proposed and experimentally demonstrated. Each displacement sensor is formed by a fiber loop mirror combined with a long period grating. This high reflectivity variable mirror is suitable to be interrogated by an OTDR and to be multiplexed in a crosstalk free setup with temperature independence.

Abstract
In this paper, we demonstrate the interrogation of fiber optic intensity sensors by using the combination of the frequency-modulated continuous wave concept with the spectral selective reflectivity of fiber Bragg gratings. Thus, we multiplex these kinds of sensors with this technique having simultaneously a referenced system. The basis of this dual functionality is described and results are presented for the case of interrogation of two multiplexed intensity sensors. Their evaluation permits to establish the conditions to address a sensor network of this type. Also, it is proposed a strategy to implement this sensing approach without the requirement of using optical fiber delay lines in the sensor heads.

Abstract
An electrical dynamic interrogation technique is reported for long-period grating sensors relying on the modulation of fibre Bragg gratings located in the readout unit that permits us to attenuate the effect of the 1/f noise of the photodetection, amplification and processing electronics on the sensing head resolution. The concept is tested to detect variations of curvature, and a resolution of 9.4 x 10(-3) m is achieved.

Abstract
A 253km ultralong remote displacement sensor system based on a fiber loop mirror interrogated by a commercial optical time-domain reflectometer is proposed and experimentally demonstrated. The use of a fiber loop mirror increases the signal-to-noise ratio, allowing the system to interrogate sensors placed 253km away from the monitoring system without using any optical amplification. The displacement sensor was based on a long period grating spliced inside of the loop mirror, which modifies the mirror reflectivity accordingly to the applied displacement. (C) 2011 Optical Society of America