Abstract
This work studies the influence of an Erbium-Doped Fiber Amplifier (EDFA) on the phase variation of light in an optical fiber. To this end, the state of polarization (SOP) was measured as a function of optical power by adjusting the EDFA amplification, for two different laser output powers (2 dBm and 5 dBm). Results show that phase variation correlates with changes in optical power in both cases.

Abstract
The present letter proposes the implementation of Vernier-effect harmonics through the virtualization of different reference cavities. A Fabry-Perot interferometer (FPI), actuated by a piezoelectric transducer (PZT), was employed as the sensing element. Subsequently, the sensitivity of the dynamic range was investigated for both the individual interferometer and the implementation of the Virtual Vernier effect. A sensitivity of (8 +/- 0.05)x10(-3) nm/nm was achieved for the single sensor measurement. Considering the implementation of the Vernier effect, the following sensitivities were obtained: (65.6 +/- 0.08)x10(-3) nm/nm for the fundamental, (132 +/- 1)x10-3 nm/nm for the first harmonic, and (192 +/- 1)x10(-3) nm/nm for the second harmonic. Furthermore, a maximum dynamic range of 11.25 mu m and a maximum resolution of 5 pm were achieved. This study highlights the advantages of simultaneously measuring both a single sensor cavity and a harmonic of the Virtual Vernier effect, in order to achieve large dynamic ranges along with high resolution.

Abstract
In this letter, we propose a method for utilizing the internal cavities of optical circulator devices-commonly referred to as parasitic cavities-as optical reference cavities. The method involves using an optical circulator operating at 1550 nm, illuminated by a light source at 1330 nm, thereby enhancing the amplitude of the interferometric signals generated by the internal optical cavities. The system was characterized by using both an Optical Spectrum Analyzer (OSA) and the Low-Coherence Interferometry (LCI) technique. Experimental results indicate that the Optical Path Difference (OPD) remains constant with varying aperture sizes, thereby confirming the feasibility of employing the optical circulator as a reference sensor. Finally, its performance as a reference sensor is demonstrated through its integration with an external cavity that functions as a displacement sensor.

Abstract
In this study, we demonstrate the measurement of electric power using an optical ground wire ( OPGW). The tests were conducted on an OPGW cable from a high-voltage transmission line in Sines, Portugal, operating at 400 kV. A buried fiber position, free of 50 Hz and 100 Hz frequency interference, was selected to confirm that the 50 Hz frequency is not due to mechanical perturbation or electronic noise. Additionally, two suspended fiber positions (at 2500 m and 8500 m), where these frequencies were clearly observed, were analyzed. This study also examined the positioning of poles and splice detection between cables.

Abstract
Azobenzenes are a class of compounds which allow the writing and erasure of linear birefringence along any desired direction, through their ability to photoisomerize. This property enables applications requiring polarization control, which, despite extensive exploration in the visible spectrum, have yet to be fully capitalized in the infrared region. This study aims to systematically characterize the creation and relaxation of induced linear birefringence dynamics in azopolymers thin films for the 1550 nm region. Maximum birefringence values as high as 6.02 x 10(-2) were attained during the recording phase with a 445 nm pump laser, that stabilized at 5.40 x 10(-2) during the relaxation phase, achieved for a 2.4 mu m sample. In addition, a maximum phase shift of Delta Phi = 0.54 pi stabilizing at Delta Phi = 0.50 pi, was observed for a 9.7 mu m sample with a 532 nm writing laser. Accordingly, this shows the promising potential of azopolymers for many applications.

Abstract