Abstract
Autonomous Underwater Vehicles (AUVs) are seen as a safe and cost-effective platforms for performing a myriad of underwater missions. These vehicles are equipped with multiple sensors which, combined with their long endurance, can produce large amounts of data, especially when used for video capturing. These data need to be transferred to the surface to be processed and analyzed. When considering deep sea operations, where surfacing before the end of the mission may be unpractical, the communication is limited to low bitrate acoustic communications, which make unfeasible the timely transmission of large amounts of data unfeasible. The usage of AUVs as data mules is an alternative communications solution. Data mules can be used to establish a broadband data link by combining short-range, high bitrate communications (e.g., RF and wireless optical) with a Delay Tolerant Network approach. This paper presents an enhanced version of UDMSim, a novel simulation platform for data muling communications. UDMSim is built upon a new realistic AUV Motion and Localization (AML) simulator and Network Simulator 3 (ns-3). It can simulate the position of the data mules, including localization errors, realistic position control adjustments, the received signal, the realistic throughput adjustments, and connection losses due to the fast SNR change observed underwater. The enhanced version includes a more realistic AML simulator and the antenna radiation patterns to help evaluating the design and relative placement of underwater antennas. The results obtained using UDMSim show a good match with the experimental results achieved using an underwater testbed. UDMSim is made available to the community to support easy and faster evaluation of underwater data muling oriented communications solutions and to enable offline replication of real world experiments.

Abstract
The demand for cost-effective broadband wireless underwater communications has increased in the past few years, motivated by the video collection performed by Autonomous Underwater Vehicles (AUVs) in areas such as environmental monitoring and oil and gas industries. However, the current technological limitations make it hard to implement a viable broadband wireless communications system for transferring the large amounts of data collected. Existing underwater communications solutions, using wireless optical or Radio Frequency (RF), limit high definition wireless video transfer to distances up to tens of meters. In case of underwater acoustic communications, long ranges can be achieved, but the low bandwidth makes them unsuitable for video streaming, even for standard definition video.In this paper we propose a solution, named Underwater Adaptive and Reliable Video Streaming (UARVS), that offers a video streaming service built upon the GROW data muling approach. UARVS exploits the use of data mules - small and agile AUVs - that travel between two physical nodes, bringing the data from an underwater survey unit to a central station at the surface. To validate the solution, an experimental testbed was built using airtight PVC cylinders, on a freshwater tank. The experimental results obtained show that UARVS enables an adaptive and continuous flow of video, avoids butter underruns, and reacts to data mule losses and delays.

Abstract
In the last few decades, there has been a growing interest in exploring the sea. The activities of the so-called blue economy can go from applications such as offshore maritime wind farms to ocean environment monitoring, which are supported by sensed platforms such Autonomous Surface Vehicles (ASVs) and Autonomous Underwater Vehicles (AUVs) that require the use of reliable underwater communications. Currently, there is no suitable solution that is able to combine long-range and broadband underwater communications. The integration of different technologies, namely acoustics, RF, and optical on a multimodal approach, has been considered a suitable solution to overcome the limitations caused by the water propagation medium. Since missions at the ocean are usually expensive and demand large human and technological resources, it is important to have accurate simulation platforms for these multimodal underwater wireless networks. This paper presents the first version of a novel simulation framework - MultiUWSim (Beta) -, built upon ns-3, which integrates multiple communications technologies (RF, acoustics and optical). The current version of the simulation platform offers the possibility of simulating acoustic-based and radio-based physical wireless interfaces in a single node in a ns-3 simulation environment, enabling fully-customizable underwater network simulations.

Abstract
This paper introduces a novel service-oriented framework, Radio Propagation as a Service (RPaaS), that bridges the gap between raw sensor data and high-fidelity wireless channel simulations. RPaaS transforms noisy, sensor-derived point clouds into accurate 3D models through robust registration, segmentation, and edge detection. These models then feed into a GPU-accelerated ray tracing engine that computes multipath propagation effects, while a separate module derives key electromagnetic and channel parameters. All components are orchestrated via a REST API in a Dockerized environment, enabling dynamic reconfiguration based on sensor data conditions. Experimental validation against commercial ray tracing tools and channel measurements demonstrates that our approach provides accurate simulations even in the presence of sensor noise. © 2025 European Signal Processing Conference, EUSIPCO. All rights reserved.

Abstract
Telecommunications and computer vision have evolved independently. With the emergence of high-frequency wireless links operating mostly in line-of-sight, visual data can help predict the channel dynamics by detecting obstacles and help overcoming them through beamforming or handover techniques. This paper proposes a novel architecture for delivering real-time radio and video sensing information to O-RAN xApps through a multi-agent approach, and introduces a new video function capable of generating blockage information for xApps, enabling Integrated Sensing and Communications. Experimental results show that the delay of sensing information remains under 1 ms and that an xApp can successfully use radio and video sensing information to control the 5G/6G RAN in real-time.

Abstract
Telecommunications and computer vision solutions have evolved significantly in recent years, allowing a huge advance in the functionalities and applications offered. However, these two fields have been making their way as separate areas, not exploring the potential benefits of merging the innovations brought from each of them. In challenging environments, for example, combining radio sensing and computer vision can strongly contribute to solving problems such as those introduced by obstructions or limited lighting. Machine learning algorithms, able to fuse heterogeneous and multi-modal data, are also a key element for understanding and inferring additional knowledge from raw and low-level data, able to create a new abstracting level that can significantly enhance many applications. This paper introduces the CONVERGE vision-radio concept, a new paradigm that explores the benefits of integrating two fields of knowledge towards the vision of View-to-Communicate, Communicate-to-View. The main concepts behind this vision, including supporting use cases and the proposed architecture, are presented. CONVERGE introduces a set of tools integrating wireless communications and computer vision to create a novel experimental infrastructure that will provide open datasets to the scientific community of both experimental and simulated data, enabling new research addressing various 6 G verticals, including telecommunications, automotive, manufacturing, media, and health.