Abstract
In this paper, we present a continuous-wave tunable fibre ring laser operating in the L-band. A bi-directional pumped L-band erbium-doped fibre amplifier provides gain to the loop. Tunability is achieved by bending a single-mode fibre taper using a micrometer drive, controlling in this way the spectral cavity losses. Laser emission is achieved between 1587 and 1606 nm, and low variation of the output laser power is observed over all the tuning range.

Abstract
A fibre Bragg grating interrogation technique with tunable sensitivity is reported. It relies on the utilization of the edge filtering concept applied to a chirped fibre Bragg grating (CFBG) written in an erbium-doped fibre as the processing element. Through the combination of the optical gain properties of the erbium-doped fibre and of the distributed wavelength reflection characteristics of the CFBG, it is possible to achieve different reading sensitivities and amplification of the remote sensing signal.

Abstract
A full characterization of reversible long-period fibre gratings produced through the wind of a string around a fibre/grooved tube set is presented. This technique enables a good control over the gratings isolation loss-peaks and has high repeatability. The tunability of the resonant wavelengths through the etching of the fibres cladding, prior to perform the gratings, have been investigated. These mechanically induced long-period fibre gratings have shown high sensitivity to loads.

Abstract
A new scheme based on four-wave mixing is presented using a ring erbium-doped fibre laser and tuneable fibre Bragg gratings that can effectively perform wavelength conversion in a wide wavelength range. An application of this wavelength-conversion architecture to optical communications is also presented.

Abstract
Two different architectures of multiplexers/demultiplexers based on 4 x 1 and 1 x 4 configurations are discussed. These architectures are implemented using apodized fibre Bragg gratings as optical filters and optical circulators. The spectral characteristics of the devices for channel separations of 100 GHz and 50 GHz are analysed and their performance is evaluated. Optical switch and cross-connect configurations are also demonstrated.

Abstract
In this paper we present and evaluate the spectral response of uniform gratings written in different tapered core sections of single mode fibre. This combination of uniform gratings and tapers leads to three, types of Chirped Fibre Bragg Gratings with different reflection spectra and different mechanical properties. These devices are characterized in function of the applied strain, showing interesting chirp tunability.