Abstract
In this work the concept of long period based optical fibre sensors with the broadband light illumination generated just after the sensing structure is presented. This new approach allows the interrogation in transmission of the sensing head while integrated in a reflective configuration, which means the LPG sensor is seen in transmission by the optical source but in reflection by the measurement system. Also, it is shown that with this illumination layout the optical power balance is more favorable when compared with the standard configurations, allowing better sensor performances particularly when the sensing head is located far away from the photodetection and processing unit. This is demonstrated for the case of the LPG structure applied to measure strain and using ratiometric interrogation based on the readout of the optical power reflected by two fibre Bragg gratings spectrally located in each side of the LPG resonance.

Abstract
This work describes a large-core air-clad photonic crystal fibre-based sensing structure that is sensitive to refractive index, temperature and strain. The sensing head is based on multimodal interference, and relies on a single mode - large-core air-clad photonic crystal fibre - single mode fibre configuration. Using two distinct large-core air-clad PCF geometries it is possible to obtain an optical spectrum with two dominant loss bands, at wavelengths that have different sensitivities to physical parameters. This characteristic is explored to demonstrate a sensing head that permits the strain-temperature discrimination functionality. It is also shown the large-core air-clad photonic crystal fibre can be applied to implement a sensing head sensitive to the water refractive index changes induced by temperature variations.

Abstract
It is described a fibre optic sensor for liquid refractive index measurement based on the visibility variations of a Fabry-Perot interferometer with interfering waves generated in a short Bragg grating and in the fibre tip (Fresnel reflection) in contact with the liquid. The sensor was characterized emerging the fibre tip in distilled water with different concentrations of ethylene glycol. A linear relation was obtained, with a readout resolution of similar to 10(-3). It was also observed that the temperature direct cross sensitivity is residual.

Abstract
Optical fibre sensors for Hydrogen detection at low concentrations has become a growing research area using Palladium as an active medium. Palladium is widely used in hydrogen sensing as it show a high and selective affinity for hydrogen. This metal is capable to absorb hydrogen up to 900 times its own volume which permits that during the expansion mechanical forces are applied in the fibre modifying the optical response. Several optical fibre hydrogen sensor heads coated with Palladium are presented and compared using different working principles: interferometric, intensity and fiber grating-based sensors. These principles were applied in Fabry-Perot cavities, fibre Bragg gratings written in fibre SMF28 with etching in the cladding, multimode interferometers and fibre end micro-mirrors. Palladium thin film coatings over the fibre surface and with thicknesses from 10nm to 350nm were produced by using the sputtering RF technique. These studies were performed in a Hydrogen/Nitrogen atmosphere with Hydrogen concentrations from 0% to 4% (lower limit explosion). The Bragg grating inscribed in a fibre with reduced cladding diameter appears to be one of the best approaches for a fibre optic sensing head for Hydrogen detection. Future work will continue the investigation of other fibre optic structures with Hydrogen sensing capabilities and their application in specific field situations will be assessed.

Abstract
The interrogation of a suspended-core Fabry-Perot interferometric cavity through the illumination of a dual wavelength Raman fiber laser is reported. The proposed scheme is based on the use of a dual wavelength source for the generation of two quadrature phase-shifted signals that allows the recovery of the temperature change. The dual wavelength Raman fiber laser is based on fiber Bragg gratings combined with a virtual mirror. The use of this source allows a passive and accurate interrogation of the temperature variation, while taking advantage of the Rayleigh scattering growth as a virtual mirror in the laser.

Abstract
An all fibre Mach-Zehnder interferometric configuration based on a suspended twin-core fibre is described. Due to the birefringence of the fibre cores, two interferometers were obtained by illuminating the fibre with polarized light. Applying strain, curvature and temperature to the sensing head, different sensitivities were observed, which permits the use of the matrix method to discriminate these three measurands.