Cookies
Usamos cookies para melhorar nosso site e a sua experiência. Ao continuar a navegar no site, você aceita a nossa política de cookies. Ver mais
Fechar
  • Menu
Sobre

Sobre

Vítor Amorim recebeu o seu grau de licenciado e mestre pela universidade do Porto em 2014 e 2016, respetivamente. Atualmente ele está a trabalhar no seu doutoramento na mesma instituição. Ele é colaborador do INESC TEC desde 2015. Os seus interesses atuais incluem a fabricação de dispositivos óticos integrados em silica fundida por escrita direta com laser femtosegundo.

Tópicos
de interesse
Detalhes

Detalhes

001
Publicações

2019

Loss Mechanisms of Optical Waveguides Inscribed in Fused Silica by Femtosecond Laser Direct Writing

Autores
Amorim, VA; Maia, JM; Viveiros, D; Marques, PVS;

Publicação
Journal of Lightwave Technology

Abstract

2019

High Performance Titanium oxide coated D-shaped Optical Fiber Plasmonic Sensor

Autores
Gangwar, RK; Amorim, VA; Marques, P;

Publicação
IEEE Sensors Journal

Abstract

2019

Spectral Tuning of Long Period Fiber Gratings Fabricated by Femtosecond Laser Micromachining through Thermal Annealing

Autores
Viveiros, D; Almeida, JMMMd; Coelho, L; Vasconcelos, H; Amorim, VA; Maia, JM; Jorge, PAS;

Publicação
Proceedings

Abstract
A femtosecond laser direct writing system was developed to explore the fabrication of long-period fiber gratings (LPFGs) in SMF28 fibers. The LPFGs, showing the mode LP1,6 at 1500 nm, were exposed to high-temperature annealing up to 950 °C. Modifications in the refractive index (RI) modulation are observed through a blue-shift in the LPFG attenuation bands and above 850 °C, the mode LP1,7 appear at 1600 nm. The wavelength sensitivity to external RI from 1.300 to 1.452 was estimated for both modes before and after annealing. Greater sensitivity was found for the higher order mode in the entire range reaching 2400 nm/RIU around 1.440.

2018

Fabrication of Monolithic Add-Drop Filters in Pure Silica by Femtosecond Laser Writing

Autores
Marques, PVS; Amorim, VA; Maia, JM; Alexandre, D; Viveiros, D;

Publicação
International Conference on Transparent Optical Networks

Abstract
This paper will review the fabrication of monolithic integrated optical devices by laser direct writing with femtosecond pulsed laser sources, starting with the description of experimental procedures and optimal conditions to fabricate low loss optical waveguides, directional couplers, Y-junctions and first order Bragg gratings by point-by-point writing methods. Finally, the characterization results of a fully operational Add-Drop filter in pure fused silica substrate are described. © 2018 IEEE.

2017

Optimization of Broadband Y-Junction Splitters in Fused Silica by Femtosecond Laser Writing

Autores
Amorim, VA; Maia, JM; Alexandre, D; Marques, PVS;

Publicação
IEEE PHOTONICS TECHNOLOGY LETTERS

Abstract
Optical Y-junction power splitters owe their inherent broadband spectral behavior to their design. However, depending on the fabrication technique employed, asymmetries in the junction might arise, perturbing its performance; this is the case in femtosecond laser written Y-junctions where one arm is typically written over the top of the other. In this letter, the spectral behavior of Y-junctions fabricated in fused silica by the femtosecond laser direct writing technique was analyzed and optimized for the first time, to the best of our knowledge. The junction arms output power balance as well as the corresponding spectral flatness between 1300 and 1600 nm is substantially increased by the implementation of an initial separation between the arms at the junction diverging point, enabling the manufacturing of balanced broadband Y-junctions.