Abstract
The wavelength sensitivity and spectral resolution of Mach-Zehnder fiber interferometers obtained through a combination of two identical uncoated and titanium dioxide (TiO2) coated long period fiber gratings (LPFGs) is presented and compared with single LPFGs-based refractometric sensors. A set of LPFGs were fabricated in single mode fiber with the resonance band having an amplitude of 3 dB in order to split in half the optical power between the core and the specific cladding modes. The separation between the pair of LPFG written in the fiber was varied between 1 and 3 cm and the thickness of the TiO2 coating around the fiber ranged from 20 to 40 nm. A wavelength shift sensitivity of 216 nm/refractive index units (RIU) was achieved for the device with 3 cm and a 30-nm thick TiO2 coating, which presented a spectral resolution of 1.1 x 10(-4 )Rill Despite the lower wavelength shift sensitivity of 142 nm/RIU, attained for a 2-cm long device and 30-nm thick TiO2 coating, a spectral resolution of 1.8 x 10(-5) RIU was measured, which is one order of magnitude lower than a single LPFG.

Abstract
High concentration of biogenic amines (BA) is an indicator of deterioration of food and the determination of their concentration is an important method of food control. The hydrogen peroxide (H2O2) is a side product of the degradation of BAs by certain enzymes. It is presented an experimental technique grounded on chemiluminescence to measure small quantities of H2O2 with concentrations as low as 0.01%w/w up to 0.08%w/w. Luminol and cobalt hydroxide are added to hydroxyethyl cellulose to obtain an active membrane which will react with the sampling solution and the amount of total light emission is directly related to the H2O2 concentration.

Abstract

Abstract
Long Period Fibre Gratings (LPFGs) were fabricated by femtosecond (fs) laser direct writing in a standard single-mode fibre (SMF-28e) to measure variations in the surrounding refractive index (SRI). The sensing sensitivity of these structures was optimized with the deposition of homogeneous thin layers of titanium dioxide (TiO2) by physical vapour deposition (PVD) process. A set of LPFGs were coated with different thickness layers of TiO2, and the spectral features were monitored for different SRI solutions. The wavelength shift and the optical power variation of the LPFG minimum attenuation band were measured achieving sensitivities of similar to 570 nm/RIU at using SRI near to 1.3600 in the case of the LPFG coated with 60 nm of TiO2, a 10-fold increase over the corresponding for a bare LPFG. For SRI values higher than the cladding refractive index, a sensitivity over similar to 3000 nm/RIU was determined for 30 nm of TiO2 thick film, a region where the bare LPFGs are useless. For 30 nm of TiO2, the optical power variation follows a quasi-linear function of the SRI, with a range of similar to 10 dB. Moreover, values as high as 50 and 120 dB/RIU at 1.3200 and 1.4200, respectively, can be obtained by choosing the proper film thickness. Preliminary studies revealed that coating fs-laser direct writing LPFGs with titanium dioxide improves their performance.

Abstract
Long period fiber gratings (LPFGs) were fabricated in a standard single mode fiber (SMF-28e) through femtosecond (fs) laser direct writing. LPFGs with longer and shorter periods were fabricated, which allows coupling from the fundamental core mode to lower and higher order asymmetric cladding modes (LP(1,6)and LP1,12, respectively). For the grating periods of 182.7 and 192.5 mu m, it was verified that the LP(1,12)mode exhibits a TAP at approximately 1380 and 1448 nm in air and water, respectively. Characterization of the LPFGs subjected to high-temperature thermal treatment was accomplished. Fine-tuning of the resonance band's position and thermal stability up to 600 degrees C was shown. The temperature sensitivity was characterized for the gratings with different periods and for different temperature ranges. A maximum sensitivity of -180.73, and 179.29 pm/degrees C was obtained for the two resonances of the 182.7 mu m TAP LPFG, in the range between 250 and 600 degrees C.

Abstract
Biogenic amines, such as putrescine are potential indicators of food storage condition and deterioration. The real time measurement of their concentration in food may become an important method of food control. It was found that putrescine diffuses through a thin layer made from a solution of Poly(ethylene-co-vinyl acetate) (PEVA) and maleic anhydride. Poly(ethylene-co-vinyl acetate) is a common non-chlorinated vinyl capable to adsorb specific analytes as putrescine which upon diffusion, reversibly binds to the maleic anhydride causing the polymer swelling resulting in spectral changes from the optical point of view. Long Period Fiber Gratings coated with 30 nm titanium dioxide, a high refractive index material used to increase the intrinsic sensitivity to the external refractive index, were overcoated with a thin layer of maleic anhydride doped Poly(ethylene-co-vinyl acetate). When exposed to solutions containing small concentrations of putrescine the resonant band corresponding to the LP1,6 cladding mode was found to move to shorter wavelengths. The observed blue shift corresponds to the increasing concentration of putrescine in the fiber sensor structure. Further work is being carried out to improve the sensitivity and the limit of detection of the sensing system as well as to increase range of operation, which is presently limited to 0.3 to 0.5 M.